PL  PL EN  ENG RU  RUS UA  UA

systemypomiarowe.pl

Close-up of the assembled P161002 board with Microchip devices in SMD packages Board visualisation with an STM32 microcontroller, SD card socket and GPS module Three-dimensional visualisation of a board with a relay, buzzer and connectors Part of a schematic with an INA326 instrumentation amplifier and MCP3304 A/D converter Three-dimensional visualisation of a densely populated communication module board Device front panel with labelled buttons, volume knobs and a speaker Technical drawing of the front panel showing the layout of buttons and knobs Assembled board with a PIC18F2550 microcontroller, USB socket and trimmer potentiometers TouchGFX interface source code for STM32 in the Visual Studio Code editor Printed circuit board layout with copper layers and component placement
❮
❯
Main page Offer
Posturograph Medical data recorder RFID system BlueTooth module Aquarium controller Remote control over a telephone line RGBW LED controller Six-channel LED controller Five-channel relay controller Relay controller 4 outputs / 4 inputs HTTP server controller Gas boiler controller Measuring probe
Introduction Versions of the device Getting started GPIO port Frontpanel, the expansion module ez430-rf2500 HD camera Infrared remote control Remote desktop UART port I2C - driving an RGB LED PHP application Internet radio
24 x 24 LED display
ADC converter Voltage divider HEX / DEC / BIN converter Bicycle gear ratios
Contact details Contact form

Measuring probe

The measuring probe reads temperature using DS1820 sensors connected over a 1-Wire bus.

Visualisation of the measuring probe board with DS1820 sensors

Fig. The printed circuit board - visualisation.

Measuring probe - board seen from the component side

Fig. The printed circuit board - the real thing.

Measuring probe - printed circuit board with the 1-Wire bus

Fig. The printed circuit board - the real thing.


Copyright ©2026 systemypomiarowe.pl.